1. Home
  2. Knowledge Base
  3. Charge your CardioWatch 287-2B

Charge your CardioWatch 287-2B

Depending on your settings, the battery life of your CardioWatch varies between 1 to 5 days. When notified, please put the charger on the bracelet for a few hours.

Steps to charge your CardioWatch

  1. Plug the USB cable
  2. Connect the magnetic cable to the back of the CardioWatch as illustrated below.


When the CardioWatch is charging, the green LED on the side starts blinking.

Note that if your CardioWatch is completely flat, it will take a few seconds before you see the green LED blinking on the side of the CardioWatch. This is the time needed for your CardioWatch to restart.

Please put the bracelet on a flat surface to make sure that the charger won’t disconnect from the bracelet.

CardioWatch charging status

Charging

When the green LED on the side is blinking, your CardioWatch is charging.

Fully charged

When the green LED on the side is continuously on, your CardioWatch is fully charged.

Not charging

When the green LED on the side is continuously off, your CardioWatch is not charging.

Tips and tricks

While charging, it is recommended to put your CardioWatch:

  • on a flat surface
  • on its back (rather than on its side)

There are magnets to hold the charger in place, but the charger might still come off easily if tilted.

Troubleshooting

The green LED is off

Your watch is not charging. Please check the following points:

1. Is your charger is properly connected to the CardioWatch?

Check that your cable is not tilted and that the whole surface of the charger is in contact with the CardioWatch, as illustrated below.

Charger in wrong position:

the CardioWatch is NOT charging

Charger in correct position:

the CardioWatch is charging

2. Is your charger powered up?

Check that the USB connector is connected to a power supply.

The green LED is on

Your CardioWatch is fully charged! You can remove it from the charger and wear it.

Was this article helpful?